Subaru B9 TRIBECA WX 2007 Manual page 698

asieps_tobira.book 36 ページ ２０１２年２月１０日 金曜日 午後３時２６分
LIGHTING SYSTEM
33.Ignition Switch Illumination
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the screws, and detach the upper col-
umn cover and lower column cover.
3) Disconnect the ignition switch illumination con-
nector (A).
4) Turn the ignition switch illumination connector to
the left and disconnect it.
(B)
(C)
(A) Ignition switch illumination connector
(B) Ignition switch illumination
(C) Immobilizer antenna connector
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Step
1 CHECK THE IGNITION SWITCH ILLUMINA-
TION.
Make sure the ignition switch illumination illumi-
nates when driver's side door is open.
2 CHECK THE IGNITION SWITCH ILLUMINA-
TION.
Make sure the ignition switch illumination blinks
when the ignition switch is turned to ON.
Ignition Switch Illumination
SL-00258
(A)
LI-00343
Check
Does the ignition switch illumi-
nation illuminate?
Does the ignition switch illumi-
nation blink?
LI-36
Yes No
Ignition switch illu- Go to step 2.
mination is normal.
Check the function Check the ignition
setting of body switch illumination
integrated unit. circuit. <Ref. to SL-
<Ref. to 22, CHECK IGNI-
LAN(diag)-2, Basic TION SWITCH
Diagnostic Proce- ILLUMINATION.,
dure.> INSPECTION,
Keyless Entry Sys-
tem.>