Subaru B9 TRIBECA WX 2007 Manual page 32

asieps_tobira.book 9 ページ ２０１２年２月１０日 金曜日 午後３時２６分
19.SEAT
1) Check the seat surfaces for stains or dirt.
2) Check that each seat provides full functionality in
sliding and reclining. Check all available functions
of the rear seat such as a trunk-through center arm-
rest.
3) Check the occupant detection system for pas-
senger's seat.
(1) Turn the ignition switch to ON.
(2) Check that the ON and OFF passenger side
airbag indicator light simultaneously for approx-
imately six seconds, extinguish for two seconds
and then only the OFF light lights.
(3) Have a person weighing approximately 70
kg (155 lb) or more sit in the passenger's seat,
and check whether the passenger's airbag indi-
cator lump lights or not.
(4) Empty the passenger seat, then check
whether the passenger side airbag indicator
light turns off.
20.SEAT BELT
1) Check installation condition of seat belt.
2) Pull out the seat belt and then release it. Check
that the belt retracts smoothly.
3) Check seat belt warning function.
(1) Turn the ignition switch to ON without fas-
tening driver's and passenger's seat belts.
(2) Check if the Seat belt warning lights of driv-
er's and passenger's side blink for about six
seconds and the buzzer beeps intermittently.
(3) Then, check that the seat belt warning light
comes on, and flashes and that the buzzer
beeps in about 15-second cycles. (If the pas-
senger seat is empty, the seat belt warning light
for passenger side does not operate.)
21.WHEEL ALIGNMENT
Check the wheel alignment. <Ref. to FS-7, Wheel
Alignment.> <Ref. to RS-8, Wheel Alignment.>
Pre-delivery Inspection
22.TEST MODE CONNECTOR
Turn the ignition switch to ON and check that the
malfunction indicator light starts blinking. If the light
blinks, return the ignition key to LOCK. Peel the
mat at the back of the glove box lower cover and
pull out the test mode connector. Then disconnect
the test mode connector. Then, turn the ignition key
to ON again. If the malfunction indicator light blinks
at that time in spite of the disconnected test mode
connector, carry out an engine diagnosis.
(A) Test mode connector (green)
PI-00295
23.IMMOBILIZER SYSTEM
1) Check that the engine starts with all keys that
are equipped on vehicle.
2) 60 seconds after turning ignition switch from ON
to ACC or OFF, or immediately after removing the
key, check that the security indicator light blinking.
NOTE:
If malfunctions occur, refer to "IMMOBILIZER (DI-
AGNOSIS)".
24.STARTING CONDITION
Start the engine and check that the engine starts
smoothly. If the battery voltage is low, recharge or
replace the battery. If there are any noises when
starting, immediately stop the engine and check
and repair the abnormal components.
25.EXHAUST SYSTEM
Listen to the exhaust noise to see if no noises are
observed. Check for exhaust leaks.
26.INDICATOR AND WARNING LIGHTS
Check that all the indicator and warning lights are
off.
27.CLOCK
Check the clock for normal operations and enough
accuracy.
28.AUDIO
Check the radio for full functionality and normal
noise level. Check the CD player and AUX opera-
tions.
PI-9
PRE-DELIVERY INSPECTION
(A)
PI-00297