Subaru B9 TRIBECA WX 2007 Manual page 803

asieps_tobira.book 27 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Step
7 CHECK SECURITY ALARM OPERATION.
1) Unlock all doors using the door lock switch
on driver's door.
2) Open any door or rear gate.
8 CHECK SECURITY ALARM OPERATION.
Check the security alarm operation.
9 CHECK SECURITY ALARM CANCEL OPER-
ATION.
Press any button of transmitter while operating
security alarm. Or turn the ignition switch to
OFF → ON three times.
10 CHECK SECURITY SYSTEM CONDITION
MEMORY.
Check that the system function properly when
the battery is not connected temporally. <Ref. to
SL-28, CHECK SECURITY SYSTEM CONDI-
TION MEMORY, INSPECTION, Security Sys-
tem.>
11 CHECK IMPACT SENSOR.
Check the sensibility of impact sensor. <Ref. to
SL-48, CHECK IMPACT SENSOR, ADJUST-
MENT, Impact Sensor.>
CAUTION:
• Security alarm ON/OFF setting
At the time of shipment from the factory, the security alarm is set to "ON". However, when {Security
setting initialization} is performed with the Subaru Select Monitor, the security alarm automatically is
set to "OFF". When security initialization has been performed, always return the ON/OFF setting for
the security alarm to "ON".
• Siren YES/NO setting
The {Siren YES/NO} setting of the item {Unit customization} of the Subaru Select Monitor always
shall be set to "NO". If it is set to "YES", the horn of the security alarm will not sound.
Security System
Check
Does the security alarm oper-
ate when opening any door or
rear gate?
Does all of the following secu-
rity alarm operate?
•Horn sounds
•Hazard light blinks
•Security indicator light illumi-
nates
Does all of the following secu-
rity alarm stop?
•Horn stops
•Hazard light stops
Does the system function prop-
erly when the battery is not con-
nected temporally?
Is the sensibility set properly?
SL-27
SECURITY AND LOCKS
Yes No
Go to step 8. • Check the door
switch. <Ref. to
SL-29, CHECK
DOOR SWITCH,
INSPECTION,
Security System.>
• Check the rear
gate latch switch.
<Ref. to SL-30,
CHECK REAR
GATE LATCH
SWITCH.,
INSPECTION,
Security System.>
Go to step 9. • Check horn.
<Ref. to SL-31,
CHECK HORN,
INSPECTION,
Security System.>
• Check the haz-
ard light. <Ref. to
SL-32, CHECK
HAZARD LIGHT
OPERATION,
INSPECTION,
Security System.>
Go to step 10.
Check the ignition
switch circuit.
<Ref. to SL-32,
CHECK IGNITION
SWITCH CIRCUIT,
INSPECTION,
Security System.>
Go to step 11.
Replace the body
integrated unit.
<Ref. to SL-51,
Body Integrated
Unit.>
Press the Adjust the sensibil-
UNLOCK button of ity. <Ref. to SL-48,
keyless transmit- IMPACT SENSI-
ter, and finish the TIVITY ADJUST-
diagnosis. MENT,
ADJUSTMENT,
Impact Sensor.>