Subaru B9 TRIBECA WX 2007 Manual page 546

asieps_tobira.book 13 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Diagnostics Chart for Security Indicator Light
Step
1 CHECK POWER SUPPLY CIRCUIT.
1) Disconnect the harness connector from key
warning switch.
2) Turn the ignition switch to "ACC" or "LOCK"
(with key inserted).
3) Measure the voltage between key warning
switch harness connector terminal and chassis
ground.
Connector & terminal
(B350) No. 3 (+) — Chassis ground (–):
2 CHECK KEY WARNING SWITCH.
1) Insert the ignition key to ignition switch.
(OFF or ACC)
2) Measure the resistance between key warn-
ing switch terminals.
Connector & terminal
No. 3 — No. 4:
3 CHECK KEY WARNING SWITCH.
1) Remove the ignition key from ignition
switch.
2) Measure the resistance between key warn-
ing switch terminals.
Connector & terminal
No. 3 — No. 4:
4 CHECK HARNESS BETWEEN KEY WARN-
ING SWITCH AND BODY INTEGRATED
UNIT.
1) Disconnect the harness connector from key
warning switch.
2) Disconnect the harness connector from
body integrated unit.
3) Measure the resistance between key warn-
ing switch harness connector terminal and body
integrated unit harness connector terminal.
Connector & terminal
(B350) No. 4 — (B281) No. 7:
Check
Is the voltage 10 V or more?
Is the resistance less than 1 Ω? Go to step 3.
Is the resistance 1 MΩ or
more?
Is the resistance less than 10
Ω?
IM(diag)-13
IMMOBILIZER (DIAGNOSTICS)
Yes No
Go to step 2. Check the harness
for open or short
circuit between key
warning switch and
fuse.
Replace the key
warning switch.
Go to step 4. Replace the key
warning switch.
Replace the body Repair the harness
integrated unit between key warn-
<Ref. to SL-51, ing switch and
Body Integrated body integrated
Unit.> and replace unit.
all the ignition keys
(including tran-
sponder). Execute
the registration
procedure next.
Refer to the "REG-
ISTRATION MAN-
UAL FOR
IMMOBILIZER".