Subaru B9 TRIBECA WX 2007 Manual page 344

asieps_tobira.book 15 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Front Fender
EXTERIOR BODY PANELS
3. Front Fender
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the side sill garnish. <Ref. to EI-32, RE-
MOVAL, Side Garnish.>
3) Remove the front bumper. <Ref. to EI-21, RE-
MOVAL, Front Bumper.>
4) Remove the headlight assembly. <Ref. to LI-12,
REMOVAL, Headlight Assembly.>
5) Remove the mud guard. <Ref. to EI-19, RE-
MOVAL, Mud Guard.>
6) Remove the cowl panel side.
(A)
EI-01280
7) Remove the bolt, and remove the front fender
panel.
EB-00279
B: INSTALLATION
1) Install in the reverse order of removal.
2) Install with attention to make uniform clearance
between front fender panel and front hood panel.
For the dimension of clearance, refer to "SPECIFI-
CATION" in "General Description". <Ref. to EB-2,
SPECIFICATION, General Description.>
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.5 ft-lb)
EB-15