Subaru B9 TRIBECA WX 2007 Manual page 817

asieps_tobira.book 41 ページ ２０１２年２月１０日 金曜日 午後３時２６分
13.Rear Gate Release Switch
A: REMOVAL
1) Remove the rear gate trim. <Ref. to EI-51, RE-
MOVAL, Rear Gate Trim.>
2) Remove the rear gate garnish. <Ref. to EI-52,
REMOVAL, Rear Gate Garnish.>
3) Disconnect the harness connector of the rear
gate release switch.
4) Hold the rear gate release switch hook, and re-
move the rear gate release switch.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the rear gate latch assembly works after
installation.
C: INSPECTION
1) Disconnect the harness connector of the rear
gate release switch.
2) Inspect the continuity between the rear gate re-
lease switch connector terminals.
Switch Terminals
Open
No. 1 and No. 2
Close
If NG, replace the rear gate release switch.
Rear Gate Release Switch
SL-00458
Standard
Less than 1 Ω
1 MΩ or more
SL-41
SECURITY AND LOCKS