Subaru B9 TRIBECA WX 2007 Manual page 394

asieps_tobira.book 41 ページ ２０１２年２月１０日 金曜日 午後３時２６分
13) Make sure that the instrument panel upper is
removed from the steering support beam
14) Disconnect the connectors, and remove the in-
strument panel from vehicle body.
15) Remove the heater vent duct. <Ref. to AC-51,
REMOVAL, Heater Vent Duct.>
16) Remove the air vent grille. <Ref. to AC-49, RE-
MOVAL, Air Vent Grille.>
17) Remove the passenger airbag module. <Ref.
to AB-15, REMOVAL, Passenger's Airbag Mod-
ule.>
2. STEERING SUPPORT BEAM
1) Remove the instrument panel upper.
2) Remove the bolts, and then remove the knee
guard plate.
3) Remove the steering shaft from the steering
support beam. <Ref. to PS-17, REMOVAL, Tilt
Steering Column.>
4) Remove the bolts and remove the steering sup-
port beam.
Instrument Panel Assembly
3. INSTRUMENT PANEL ASSEMBLY
1) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
2) Remove the console box. <Ref. to EI-38, RE-
MOVAL, Console Box.>
3) Remove the instrument panel lower cover. <Ref.
to EI-36, REMOVAL, Instrument Panel Lower Cov-
er.>
4) Remove the glove box. <Ref. to EI-37, REMOV-
AL, Glove Box.>
5) Remove the center console. <Ref. to EI-39, RE-
MOVAL, Center Console.>
6) Remove the front pillar upper trim. <Ref. to EI-
43, REMOVAL, Side Trim.>
7) Remove the steering shaft from the steering
support beam. <Ref. to PS-17, REMOVAL, Tilt
Steering Column.>
8) Disconnect the connectors, and remove the in-
strument panel from vehicle body.
9) Remove the bolts and remove the steering sup-
port beam.
NOTE:
For positions of the mounting bolt of steering sup-
port beam, refer to the removal procedure of the
steering support beam.
EI-01331
10) Make sure that the each harness connector is
disconnected, and remove the instrument panel as-
sembly from the vehicle body.
NOTE:
Remove the passenger's side door trim to facilitate
the work.
EI-01332
EI-41
EXTERIOR/INTERIOR TRIM