Subaru B9 TRIBECA WX 2007 Manual page 748

asieps_tobira.book 6 ページ ２０１２年２月１０日 金曜日 午後３時２６分
SEATS
B: CAUTION
• If the seat cushion cover is removed or replaced,
make sure to perform passenger detection system
adjustment after installing the seat to the vehicle.
<Ref. to OD(diag)-17, SYSTEM CALIBRATION
(REZEROING), OPERATION, Subaru Select Mon-
itor.>
Failure to do so may cause improper operation of
the passenger detection system.
• The passenger detection system (passenger
seat only) control unit and the passenger detection
sensor are fixed to the seat cushion frame. Never
remove the passenger detection control unit or the
pressure sensor from the seat cushion frame.
• Do not replace the seat cushion pad by itself. Al-
ways replace the seat cushion pad and frame as-
sembly as a set. The seat cushion pad and cushion
frame are adjusted as a set at the time of manufac-
ture. If cushion pads and cushion frames are com-
bined from those of other vehicles or other sets, the
passenger detection system may not operate prop-
erly.
• If the seat cushion cover is removed, make sure
to replace the wire on the seat cushion side with a
new wire.
• When removing the front seat from a side airbag
loaded vehicle, follow cautions given in the airbag
section. <Ref. to AB-4, CAUTION, General De-
scription.>
C: NOTE
When removing the front seat of memory-equipped
power seats, always perform the initialize operation
on the memory function after installing the seat to
the vehicle. <Ref. to SE-34, ADJUSTMENT, Power
Seat System.>
Failure to do so may cause the abnormal operation
of the memory function.
D: PREPARATION TOOL
1. GENERAL TOOL
TOOL NAME
Long nose plier Used for removing the hog ring.
Hog ring pliers Used for installing the hog ring.
Circuit tester Used for checking power seat and
seat heater.
®
TORX T50 Used for removing/installing inner
seat belt assembly and removing/
installing/disassembling second-row
seats.
General Description
REMARKS
SE-6