Subaru B9 TRIBECA WX 2007 Manual page 828

asieps_tobira.book 52 ページ ２０１２年２月１０日 金曜日 午後３時２６分
SECURITY AND LOCKS
24.Transmitter
A: REMOVAL
1. TRANSMITTER BATTERY
Remove the battery (1) from the transmitter.
NOTE:
To prevent static electricity damage to the transmit-
ter printed circuit board, touch the steel area of
building with hand to discharge static electricity car-
ried on body or clothes before disassembling the
transmitter.
B: INSTALLATION
1. TRANSMITTER BATTERY
Install in the reverse order of removal.
C: INSPECTION
1. TRANSMITTER BATTERY
Measure the voltage between the keyless transmit-
ter battery (+) terminal and (-) terminal.
NOTE:
Battery discharge occurs during the measurement.
Complete the measurement within 5 seconds.
(A) Resistance (47 Ω)
Tester connection
(+)
Battery Battery
Positive terminal Ground terminal
If NG, replace the battery. (Use CR2025 or equiva-
lent.)
Transmitter
(1)
SL-00387
(A)
SL-00066
Standard
(–)
2.5 — 3.0 V
SL-52
D: REPLACEMENT
1. REGISTRATION OF KEYLESS TRANS-
MITTER WITH SUBARU SELECT MONITOR
NOTE:
• A maximum of four keyless transmitter can be
registered for each individual vehicle.
• When replacing or adding the keyless transmit-
ter, new registration of transmitter is necessary.
1) Connect the Subaru Select Monitor to the vehi-
cle.
2) Turn the ignition switch to ON.
3) From the «Main menu» on the Subaru Select
Monitor, select the {2. Check individual system} →
{7. Integrated unit mode} → {8. Transmitter ID reg-
istration}, and press the [YES] key.
4) Input the 8-digit ID number attached to the plas-
tic bag of the keyless transmitter or inside the trans-
mitter, from left to right. Press the [Enter] key.
NOTE:
Select the [ ] on the Subaru Select Monitor to in-
crease the number, and the [ ] to decrease. Se-
lect the [<] to move to the digit in the left, and [>] to
the right.
5) The ID number you have entered will be shown.
Make sure that the ID number shown is the same
as that of plastic bag.
6) Select the [OK] if the ID number is correct. Se-
lect the [NO] if incorrect, to return to the step 3) and
try again.
7) «ID registration in process···» is displayed and
registration starts.
8) «ID registration done» will be displayed when
the registration process is done.
9) To exit, select «END:NO», and select the [NO] to
return to {8. Transmitter ID registration}. If there are
additional transmitters to be registered, select
«Next registration:OK», and select the [OK] to re-
turn to the step 3).
NOTE:
• If the registration fails, «ID registration failed. Try
again.» will be shown. Select the [OK] to return to
the {8. Transmitter ID registration}. Retry from step
2.
• «END: NO» is shown on the Subaru Select Mon-
itor when fourth keyless transmitter has been regis-
tered. Select the [NO] to return to {8. Transmitter ID
registration}.