Subaru B9 TRIBECA WX 2007 Manual page 516

asieps_tobira.book 37 ページ ２０１２年２月１０日 金曜日 午後３時２６分
17.Evaporator
A: REMOVAL
1. FRONT
1) Using the refrigerant recovery system, dis-
charge refrigerant. <Ref. to AC-21, PROCEDURE,
Refrigerant Recovery Procedure.>
2) Disconnect the ground cable from the battery.
3) Remove the blower motor unit assembly. <Ref.
to AC-27, REMOVAL, Blower Motor Unit Assem-
bly.>
4) Disconnect the connector, remove the screw
and then remove the air-mix door actuator and
mode door actuator.
5) Remove the bolts holding the expansion valve,
and remove the expansion valve.
6) Remove the screws and pull out the evaporator.
Evaporator
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
7) Remove the pipe cover from the evaporator.
8) Remove the bolt which holds the pipe to evapo-
rator, and remove the evaporator.
AC-01296
CAUTION:
When replacing the evaporator, add an appro-
priate amount of compressor oil to the evapora-
tor. <Ref.
Compressor Oil.>
2. REAR
1) Using the refrigerant recovery system, dis-
charge the refrigerant. <Ref. to AC-21, PROCE-
DURE, Refrigerant Recovery Procedure.>
2) Disconnect the ground cable from the battery.
3) Remove the rear cooler unit. <Ref. to AC-36,
REAR, REMOVAL, Heater and Cooling Unit.>
AC-01298
4) Remove the pipe bracket bolts and remove the
bracket.
AC-01300
AC-37
AC-01317
AC-01299
to AC-26, REPLACEMENT,
AC-01343