Subaru B9 TRIBECA WX 2007 Manual page 30

asieps_tobira.book 7 ページ ２０１２年２月１０日 金曜日 午後３時２６分
13.AT FRONT DIFFERENTIAL OIL
Check that the AT front differential oil level is nor-
mal. If the amount of oil is insufficient, check that no
leaks are found. Then, add the necessary amount
of the specified AT front differential oil.
(A)
(A) Oil level gauge
(B) Upper level
(C) Lower level
14.ENGINE COOLANT
Check that the engine coolant level on the reservoir
tank is normal. If the amount of engine coolant is in-
sufficient, check that no leaks are found. Then, add
the necessary amount of coolant with the specified
concentration.
15.WINDOW WASHER FLUID
Check that the window washer fluid level is normal.
If the amount is insufficient, check that no leaks are
found. Then, add the necessary amount of washer
fluid.
16.HOOD LATCH CHECK
Close the front hood. Check that the front hood is
securely latched.
17.KEYLESS ENTRY SYSTEM
NOTE:
The following inspections show the initial settings.
When the settings are different from the initial set-
tings, use Subaru Select Monitor to check the de-
tails of each setting for inspections. <Ref. to
LAN(diag)-26, OPERATION, Read Current Data.>
1) Fully open all the door windows.
2) Remove the key from the ignition switch and
close all the doors including rear gate.
Pre-delivery Inspection
3) Press the rear gate open button for more than
one second. Check if the rear gate is unlocked and
the hazard light blinks twice and the buzzer sounds
twice.
(A)
(B)
(C)
4) Press the "LOCK" button on the keyless trans-
PI-00184
mitter with one of the doors (including the rear gate)
opened. Check if all the doors are locked, hazard
light blinks five times and the buzzer sounds five
times and warning shows one of the doors (includ-
ing the rear gate) open.
5) Close all the doors including rear gate. Press the
"LOCK" button momentarily on the keyless trans-
mitter. Check that all the doors (including rear gate
and trunk) are locked, hazard light blinks once and
buzzer sounds once.
6) Press the "UNLOCK" button momentarily on the
keyless transmitter. Check that the driver's door is
unlocked and hazard light blinks twice and the
buzzer sounds twice.
And press the "UNLOCK" button momentarily
again in 5 seconds. Check that all the doors includ-
ing rear gate are unlocked.
PI-7
PRE-DELIVERY INSPECTION
PI-00254
PI-00255
PI-00256