Subaru B9 TRIBECA WX 2007 Manual page 268

asieps_tobira.book 5 ページ ２０１２年２月１０日 金曜日 午後３時２６分
3. Cruise Control Command
Switch
A: REMOVAL
CAUTION:
Before servicing, be sure to read the notes in
the "AB" section for proper handling of the
driver's airbag module. <Ref. to AB-4, CAU-
TION, General Description.>
1) Set the front wheels in straight ahead position.
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
®
4) Using TORX BIT T30 (1), loosen two TORX
bolts which secure the driver's airbag module.
5) Disconnect the airbag module connector on
back of the airbag module.
6) Remove the steering wheel. <Ref. to PS-14, RE-
MOVAL, Steering Wheel.>
7) Remove the four screws to remove the lower
cover from steering wheel.
8) Remove one screw to remove the cruise control
command switch from lower cover.
Cruise Control Command Switch
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Measure the cruise control command switch resis-
tance.
®
SET/COAST
RESUME/
(1)
SET/COAST
RESUME/
CC-00018
If NG, replace the cruise control command switch.
CC-00181
CC-00182
CC-5
CRUISE CONTROL SYSTEM
1 2 3
Switch Area Terminal No.
CANCEL
All OFF 2 and 3
ACCEL
CANCEL ON 2 and 3
ON 2 and 3
ON 2 and 3
ACCEL
OFF 1 and 2
MAIN
ON 1 and 2
CC-00252
Standard
Approx. 4 kΩ
Less than 1 Ω
Approx. 250 Ω
Approx. 1500 Ω
1 MΩ or more
Less than 1 Ω