Subaru B9 TRIBECA WX 2007 Manual page 542

asieps_tobira.book 9 ページ ２０１２年２月１０日 金曜日 午後３時２６分
7. Clear Memory Mode
A: OPERATION
1. ECM
1) On the «Main Menu» display screen, select the
{Each System Check}.
2) On the «System Selection Menu» display
screen, select the {Engine Control System}.
3) Select the [OK] after the information of engine
type is displayed.
4) On the «Engine Diagnosis» display screen, se-
lect the {Clear Memory}.
5) When the 'Done' are shown on the display
screen, turn the ignition switch to OFF and close
the Subaru Select Monitor.
NOTE:
• After the memory has been cleared, the idle air
control solenoid valve must be initialized. To exe-
cute this procedure, turn the ignition switch to ON.
Wait for 3 seconds before starting the engine.
• For detailed operation procedure, refer to the
"SUBARU SELECT
MANUAL".
2. BODY INTEGRATED UNIT
1) On the «Main Menu» display screen, select the
{Each System Check}.
2) On the «System Selection Menu» display
screen, select the {Integ. unit mode}.
3) Select the [OK] after the {Integ. unit mode} is dis-
played.
4) On the «Integ. unit mode failure diag» display
screen, select the {Clear Memory}.
5) When the 'Done' are shown on the display
screen, turn the ignition switch to OFF and close
the Subaru Select Monitor.
NOTE:
For detailed operation procedure, refer to the
"SUBARU SELECT
MANUAL".
Clear Memory Mode
MONITOR OPERATION
MONITOR OPERATION
IM(diag)-9
IMMOBILIZER (DIAGNOSTICS)