Subaru B9 TRIBECA WX 2007 Manual page 66

asieps_tobira.book 15 ページ ２０１２年２月１０日 金曜日 午後３時２６分
5. Passenger's Airbag Module
A: REMOVAL
CAUTION:
Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the glove box. <Ref. to EI-37, REMOV-
AL, Glove Box.>
4) Remove the mounting bolts of the passenger's
side airbag module.
5) Remove the instrument panel upper. <Ref. to EI-
40, INSTRUMENT PANEL UPPER, REMOVAL,
Instrument Panel Assembly.>
6) Remove the screws, and remove the passen-
ger's airbag module.
7) Refer to "CAUTION" for handling of a removed
airbag module. <Ref. to AB-4, CAUTION, General
Description.>
B: INSTALLATION
CAUTION:
Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
Install in the reverse order of removal.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.5 ft-lb)
Passenger's Airbag Module
C: INSPECTION
CAUTION:
Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
Check for the following, and replace the damaged
parts with new parts.
• Airbag module, harness, connector and mount-
ing bracket are damaged. <Ref. to AB-12, PAS-
SENGER'S AIRBAG MODULE, INSPECTION,
Inspection Locations After a Collision.>
EI-01327
AB-01276
AB-15
AIRBAG SYSTEM