Subaru B9 TRIBECA WX 2007 Manual page 769

asieps_tobira.book 27 ページ ２０１２年２月１０日 金曜日 午後３時２６分
8. SOME OF THE MOTOR DO NOT OPERATE. (DRIVER'S SEAT, WITH MEMORY)
• Malfunction of slide operation
Step
1 CHECK OPERATION.
Check the slide motor rotation while moving the
switch to slide forward and slide backward.
2 CHECK SWITCH.
1) Disconnect the harness connector of power
seat switch assembly.
2) Measure the resistance between connector
terminals when moving the switch to slide for-
ward and slide backward. <Ref. to SE-22,
CHECK POWER SEAT SWITCH, INSPEC-
TION, Power Seat System.>
3 CHECK HARNESS.
1) Disconnect the power seat switch connector
and slide motor connector.
2) Measure the resistance between the mem-
ory module connector and power seat switch
connector.
Connector & terminal
(R195) No. 7 — (R190) No. 13:
(R195) No. 6 — (R190) No. 14:
4 CHECK HARNESS.
1) Disconnect the slide motor connector.
2) Measure the resistance between the mem-
ory module connector and slide motor connec-
tor.
Connector & terminal
(R196) No. 16 — (R206) No. 1:
(R196) No. 15 — (R206) No. 2:
5 CHECK SLIDE MOTOR.
Apply battery voltage to the memory module
connector and check the motor rotation.
Connector & terminal
(R196) No. 16 (+) — (R196) No. 15 (–):
(R196) No. 15 (+) — (R196) No. 16 (–):
Power Seat System
Check
Does the motor rotate for one
seconds or more when operat-
ing the switch?
Is there any problem on the
inspection result?
Is the resistance less than 10 Ω? Go to step 4.
Is the resistance less than 10 Ω? Go to step 5.
Does the motor rotate nor-
mally?
SE-27
SEATS
Yes No
Go to step 2.
Encoder defec-
tion. Replace the
slide rail assembly.
Go to step 3. Replace the power
seat switch assem-
bly.
Check power seat
harness.
Check power seat
harness.
Replace the mem- Slide motor prob-
ory module. lem. Replace the
slide rail assembly.