Subaru B9 TRIBECA WX 2007 Manual page 425

asieps_tobira.book 18 ページ ２０１２年２月１０日 金曜日 午後３時２６分
GLASS/WINDOWS/MIRRORS
13.Windshield Glass
A: REMOVAL
1. USING THE WINDSHIELD GLASS KNIFE
1) Remove the cowl panel. <Ref. to EI-30, RE-
MOVAL, Cowl Panel.>
2) Remove the molding front.
3) Tape the body side of the circumference of wind-
shield glass for protection.
4) Apply sufficient amount of soapy water to the ad-
hesive part.
5) Insert the windshield glass knife into adhesive
part.
6) While holding the knife edge and windshield
glass edge at a right angle, move the windshield
glass knife in parallel to the windshield glass edge
along the surface and edge of windshield glass to
cut the adhesive part.
NOTE:
• Do not twist the windshield glass knife.
• Cutting of adhesive part shall be started with wid-
er gap between windshield glass and body.
(1)
A-A
(3)
(3)
(1) Windshield glass knife
(2) Tape for protection
(3) Locating pin
Windshield Glass
(1)
(1)
(2)
A
(1)
A
GW-00410
GW-18
• The locating pins are bonded to the corners of
glass. Use piano wire to disconnect the pins.
(1)
A
A
(1) Locating pin
(2) Body panel
(3) Windshield glass
2. USING PIANO WIRE
1) Remove the cowl panel. <Ref. to EI-30, RE-
MOVAL, Cowl Panel.>
2) Remove the molding front.
3) Tape the body side of the circumference of wind-
shield glass for protection.
4) Make a hole in the adhesive part using drill or
knife.
5) Pass the piano wire through the hole, and attach
both the wire ends securely to pieces of wood.
6) Pull the wire ends alternately to cut off the adhe-
sive part.
CAUTION:
• Do not tightly pull the piano wire against the
windshield glass edge.
• Be careful not to damage interior and exterior
parts.
• When removal is made with area close to in-
strument panel, place a protection plate over it.
Pay particular attention to the removal.
• Do not cross piano wires. Otherwise they
may be cut.
(2)
(3)
A-A
GW-00070
GW-00039