Subaru B9 TRIBECA WX 2007 Manual page 773

asieps_tobira.book 31 ページ ２０１２年２月１０日 金曜日 午後３時２６分
9. FAILS TO STORE THE LOCATION TO THE MEMORY (DRIVER'S SEAT, WITH MEMORY)
Step
1 CHECK SWITCH.
1) Disconnect the harness connector of mem-
ory switch assembly.
2) Perform the memory switch inspection.
<Ref. to SE-23, CHECK MEMORY SWITCH
(MEMORY-EQUPPED), INSPECTION, Power
Seat System.>
2 CHECK HARNESS.
Measure the resistance between the memory
switch connector and memory module connec-
tor.
Connector & terminal
(R195) No. 13 — (R199) No. 3:
(R195) No. 14 — (R199) No. 2:
(R195) No. 15 — (R199) No. 8:
3 CHECK COMBINATION METER.
Turn the ignition switch to ON and check the
indicator inside the meter while the select lever
is in P position.
4 SYSTEM INITIALIZATION
Perform the memory seat system initialization.
<Ref. to SE-34, ADJUSTMENT, Power Seat
System.>
Power Seat System
Check
Is there any problem on the
inspection result?
Is the resistance less than 10
Ω?
Does the indicator display P?
Is the initialization completed
successfully?
SE-31
SEATS
Yes No
Go to step 2. Replace the mem-
ory switch assem-
bly.
Go to step 3. Check power seat
harness.
Go to step 4. Check the combi-
nation meter. <Ref.
to IDI-4, INSPEC-
TION, Combina-
tion Meter
System.>
Replace the mem- <Ref. to SE-32,
ory module. INITIALIZATION IS
IMPOSSIBLE.,
INSPECTION,
Power Seat Sys-
tem.>