Subaru B9 TRIBECA WX 2007 Manual page 70

asieps_tobira.book 19 ページ ２０１２年２月１０日 金曜日 午後３時２６分
8. Airbag Control Module
A: REMOVAL
CAUTION:
• Do not disassemble the airbag control mod-
ule.
• If the airbag control module is deformed or if
the fault occurs by water, replace the airbag
control module with a new part.
• Do not drop the airbag control module.
• After removal, keep the airbag control mod-
ule on a dry, clean surface away from moisture,
heat and dust.
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the center console. <Ref. to EI-39, RE-
MOVAL, Center Console.>
4) Remove the console box. <Ref. to EI-38, RE-
MOVAL, Console Box.>
5) Remove the instrument panel lower cover. <Ref.
to EI-36, REMOVAL, Instrument Panel Lower Cov-
er.>
6) Remove the glove box. <Ref. to EI-37, REMOV-
AL, Glove Box.>
7) Remove the audio unit. <Ref. to ET-14, RE-
MOVAL, Audio.>
8) Remove the screws, and remove the center con-
sole frame.
9) Disconnect the connector from airbag control
module.
10) Remove the bolts and remove airbag control
module.
Airbag Control Module
B: INSTALLATION
CAUTION:
• Do not reuse the bolt and nut.
• Always use new bolts and nuts for them.
• Be sure to put the water protection cover
over the connector.
Install in the reverse order of removal.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
C: INSPECTION
Check for the following, and replace the damaged
parts with new parts.
• Control module, connector, and mounting brack-
et are damaged.
• Airbag is deployed.
• Side airbag is deployed.
• Curtain airbag is deployed.
AB-01280
AB-00759
AB-19
AIRBAG SYSTEM