Subaru B9 TRIBECA WX 2007 Manual page 194

asieps_tobira.book 119 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Step
1 CHECK POOR CONTACT OF CONNEC-
TORS.
Check for poor contact of the connectors
between the airbag control module and the
driver's airbag module.
2 CHECK DRIVER'S AIRBAG MODULE.
1) Turn the ignition switch to OFF, disconnect
the battery ground cable, and wait more than 20
seconds.
2) Remove the driver's airbag module.
3) Connect the connector (1N) in the test har-
ness N to the connector (AB38).
4) Connect the airbag resistor to the connector
(2N) of test harness N.
5) Connect the connector (1Q) in the test har-
ness Q to connector (AB37).
6) Connect the airbag resistor to the connector
(2Q) of test harness Q.
7) Connect the battery ground terminal and
turn the ignition switch to ON.
3 CHECK ROLL CONNECTOR.
1) Turn the ignition switch to OFF, disconnect
the battery ground cable, and wait more than 20
seconds.
2) Disconnect the test harness N from connec-
tor (AB38).
3) Disconnect the test harness Q from connec-
tor (AB37).
4) Remove the instrument panel lower cover
and disconnect the connector (AB7) from
(AB2).
5) Connect the connector (1P) in the test har-
ness P to connector (AB2).
6) Connect the airbag resistor to the connec-
tors (2P) and (3P) of test harness P.
7) Connect the battery ground terminal and
turn the ignition switch to ON.
4 CHECK AIRBAG MAIN HARNESS (DRIV-
ER'S AIRBAG HARNESS).
1) Turn the ignition switch to OFF, disconnect
the battery ground cable, and wait more than 20
seconds.
2) Disconnect the airbag resistor from the con-
nectors (2P) and (3P) of test harness P.
3) Remove the console side cover lower on the
passenger's side and disconnect the connec-
tors (AB10) and (AB9).
4) Disconnect the connector (AB6) from the
airbag control module, and connect the connec-
tor (1U) in the test harness U.
5) Measure the resistance between connector
(2U) in the test harness U and connectors (2P)
and (3P) in the test harness P.
Connector & terminal
(2U) No. 2 — (2P) No. 1:
(2U) No. 4 — (2P) No. 2:
(2U) No. 8 — (3P) No. 3:
(2U) No. 12 — (3P) No. 4:
Diagnostic Chart with Trouble Code
Is there poor contact?
Does the airbag warning light
illuminate for 6 seconds and go
off?
Does the airbag warning light
illuminate for 6 seconds and go
off?
Is the resistance less than 10
Ω?
AB(diag)-119
AIRBAG SYSTEM (DIAGNOSTICS)
Check Yes
Replace the airbag
main harness
along with body
harness.
Replace the
driver's airbag
module. <Ref. to
AB-14, Driver's Air-
bag Module.>
Replace the roll
connector. <Ref. to
AB-22, Roll Con-
nector.>
Go to step 5.
No
Go to step 2.
Go to step 3.
Go to step 4.
Replace the airbag
main harness
along with body
harness.