Subaru B9 TRIBECA WX 2007 Manual page 439

asieps_tobira.book 32 ページ ２０１２年２月１０日 金曜日 午後３時２６分
GLASS/WINDOWS/MIRRORS
22.Wiper Deicer Switch
A: REMOVAL
1) Remove the instrument panel lower cover. <Ref. to EI-36, REMOVAL, Instrument Panel Lower Cover.>
2) Disconnect the harness connector and remove wiper deicer switch.
L
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1. CHECK WITH SUBARU SELECT MONITOR
CAUTION:
Check whether the wiper deicer timer is in initial setting or customize setting before performing in-
spection.
Step
1 CHECK INPUT SIGNAL TO BODY INTE-
GRATED UNIT.
Check the input signal when the wiper deicer
switch is operated using Subaru Select Monitor.
1) Connect the Subaru Select Monitor to data
link connector.
2) Turn the ignition switch to ON.
3) Select {Integ. unit} from the «main menu».
4) Select the {Current Data Display & Save}.
5) Check the input signal when the wiper
deicer switch is set to ON.
2. CHECK SWITCH
Remove the wiper deicer switch, and measure the switch resistance.
7 6 5
15 14 13 12 11 10
Switch position Terminal No.
OFF
1 and 2
ON
Replace the wiper deicer switch if faulty.
Wiper Deicer Switch
R
OFF OFF
GW-00486
After the wiper deicer switch is
set to ON, does it turn to OFF in
15 minutes? Or does it operate
continuously?
4 3 2 1
9 8
GW-00330
Standard
1 MΩ or more
Less than 1 Ω
GW-32
Check Yes
END.
No
Replace the body
integrated unit.
<Ref. to SL-51,
REMOVAL, Body
Integrated Unit.>