Subaru B9 TRIBECA WX 2007 Manual page 702

asieps_tobira.book 4 ページ ２０１２年２月１０日 金曜日 午後３時２６分
General Description
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS)
3. General Description
A: CAUTION
1) Never remove the occupant detection control
module, occupant detection sensor and seat cush-
ion from seat frame because the occupant detec-
tion system is integrated into seat frame as one
unit.
2) Always perform "system calibration (Rezeroing)"
when removing or removing and disassembling the
passenger's seat. <Ref. to OD(diag)-17, SYSTEM
CALIBRATION (REZEROING), OPERATION,
Subaru Select Monitor.>
3) Never connect the battery in reverse polarity.
Occupant detection system may be destroyed in-
stantly.
4) Do not disconnect the battery terminals while the
engine is running.
A large counter electromotive force will be generat-
ed in the generator, and this voltage may damage
electronic parts such as occupant detection control
module.
5) Before disconnecting the connectors of each
sensor and control module, be sure to turn the igni-
tion switch to OFF and wait for 20 seconds or more.
Occupant detection control module may be dam-
aged.
6) Every occupant detection system-related part is
a precision part. Do not drop them.
7) Airbag system wiring harness is routed near the
occupant detection system.
CAUTION:
• Do not use the electrical test equipment on
airbag system circuits.
• Be careful not to damage the airbag system
wiring harness when servicing the occupant
detection system.
• Refer to "Airbag System" when repairing the
occupant detection system. <Ref. to AB(diag)-
4, CAUTION, General Description.>
B: INSPECTION
Measure the battery voltage and check electrolyte.
Standard voltage: 12 V
Specific gravity: Above 1.260
OD(diag)-4