Subaru B9 TRIBECA WX 2007 Manual page 714

asieps_tobira.book 16 ページ ２０１２年２月１０日 金曜日 午後３時２６分
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS)
7. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE (DTC)
When malfunction of the airbag system and the occupant detection system occur, the DTC stored in airbag
control module will be read out.
Refer to the DTC readout of the airbag system (diagnosis). <Ref. to AB(diag)-32, READ DIAGNOSTIC
TROUBLE CODE (DTC), OPERATION, Subaru Select Monitor.>
NOTE:
• For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION
MANUAL".
• For details concerning DTCs, refer to the "List of Diagnostic Trouble Code (Airbag system, Occupant de-
tection system)." <Ref. to AB(diag)-47, List of Diagnostic Trouble Code (DTC).> <Ref. to OD(diag)-24, List of
Diagnostic Trouble Code (DTC).>
2. DISPLAY OF STATUS INFORMATION
Check the operating condition of each sensor in the event of malfunction in seat belt buckle switch and seat
position sensor, or when the seat belt buckle switch and seat position sensor has been replaced.
1) On the «Main Menu» display screen, select the {Each System Check}.
2) On the «System Selection Menu» display screen, select the {Airbag System}.
3) On the «Airbag System» display screen, select the {Status Data}.
The following table is for support data.
Item
Seat position sensor LH
Seat position sensor RH
Seat belt buckle switch LH
Seat belt buckle switch RH
Passenger's airbag control status
*1: The seat position is forward.
*2: The seat position is rearward.
*3: Displayed when data other than before and behind the seat, such as the breakdown etc, is input.
*4: Displayed when it is initial.
*5: Seat position sensor not supported
*6: Seat belt fastened
*7: Seat belt not fastened
*8: Displayed when data other than belt fastened or not fastened, such as breakdowns is input.
*9: Seat belt buckle switch not supported
*10: Passenger's seat airbag operating state
*11: Passenger's seat airbag non-operating state
NOTE:
For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MAN-
UAL".
Subaru Select Monitor
Display contents
*1 *2
Front position /Rear position /Other
*5
––
*6 *7 *8
Buckled /Unbuckled /Other /Initial Setting
*6 *7 *8
Buckled /Unbuckled /Other /Initial Setting
*10 *11 *4
ON /OFF /Initial Setting
OD(diag)-16
*3 *3 *5
/Initial Setting /––
*4 *9
/––
*4 *9
/––