Subaru B9 TRIBECA WX 2007 Manual page 31

asieps_tobira.book 8 ページ ２０１２年２月１０日 金曜日 午後３時２６分
PRE-DELIVERY INSPECTION
7) Within a distance of 10 m (33 ft) from a vehicle,
press keyless transmitter's "LOCK" button three
times within 5 seconds. Check that the horn honks
once and that the hazard light blinks three times.
8) Move the power door lock switch to the lock po-
sition with one of doors (including the rear gate)
opened. Next, close all the doors including rear
gate. Check if all the doors are locked and buzzer
sounds once and the hazard light flashes once.
9) Check buzzer operation.
The buzzer rings when the doors are locked or un-
locked. The buzzer can be turned off if desired.
Turn the buzzer off or on with following procedure.
(1) Close all the doors including rear gate, then
remove the key from ignition key lock.
(2) Press the power door lock switch to lock or
unlock and hold it until the operation is finished.
(3) Insert the key into ignition key lock, and in-
sert and remove the key in ignition key lock 5
times 10 seconds.
(4) When finished step (3), open and close the
driver's door once within 10 seconds.
NOTE:
When opening and closing of the door is not avail-
able within 10 seconds, hazard light blinks once
and the change over operation is cancelled. Retry
from the step (1).
(5) Hazard light blinks 3 times and the buzzer
sound turns ON or OFF.
10) Press the "Panic" button on the backside of the
keyless transmitter. Check if the alarm condition
happens (horn sounds continuously, hazard light
blinks, security indicator comes on). Check wheth-
er this condition lasts until any button on the key-
less transmitter is pressed or lasts for 30 seconds.
18.ALARM SYSTEM
NOTE:
The following inspections show the initial settings.
When the settings are different from the initial set-
tings, use Subaru Select Monitor to check the de-
tails of each setting for inspections. <Ref. to
LAN(diag)-27, OPERATION, Function Setting
(Customize).>
1) Fully open all the door windows.
Pre-delivery Inspection
2) Remove the key from the ignition switch and
close all the doors including rear gate.
3) Press the "LOCK" button momentarily on the
keyless transmitter. All doors are locked, and buzz-
er sound once, hazard blinks once, security indica-
tor light blinks faster (five times per two seconds)
for 30 seconds and goes slower (twice per two sec-
onds), then the alarm system is in set condition.
4) Press the "UNLOCK" button momentarily on the
keyless transmitter. When the door of the driver's
seat is unlocked, the buzzer sounds twice, the haz-
ard light flashes twice, the room light turns on and
the security indicator light flashes once in three
seconds, and the alarm system enters the release
mode.
5) Close all the doors including rear gate. Press the
"LOCK" button momentarily on the keyless trans-
mitter. When all the doors are locked, buzzer
sounds once, hazard blinks once and the alarm
system is in set condition in 30 seconds.
6) Unlock a door using the inner lock knob and
open the door while the security system is in the set
mode. Check if the alarm condition happens (horn
sounds continuously, hazard light blinks, security
PI-00257
indicator comes on). Check if this condition lasts for
a maximum of three minutes or until the "UNLOCK"
button of the keyless transmitter is pressed.
NOTE:
The alarm condition will cease in 30 seconds once
the door is closed.
7) When none of above is applicable, check the
troubleshooting of security system.
PI-8
PI-00255
PI-00256