Subaru B9 TRIBECA WX 2007 Manual page 414

asieps_tobira.book 7 ページ ２０１２年２月１０日 金曜日 午後３時２６分
3. Power Window Control
Switch
A: REMOVAL
1. MAIN SWITCH
1) Disconnect the ground cable from the battery.
2) Peel the cover inside the hand grip, and remove
the screw.
3) Remove the power window switch cover assem-
bly.
4) Disconnect the harness connector.
5) Remove the clip, and remove the power window
main switch assembly.
2. SUB-SWITCH
1) Disconnect the ground cable from the battery.
2) Peel the cover inside the hand grip, and remove
the screw.
3) Remove the power window switch cover assem-
bly.
4) Disconnect the connector.
5) Detach the claw and remove the power window
sub-switch.
B: INSTALLATION
Install in the reverse order of removal.
Power Window Control Switch
C: INSPECTION
1. MAIN SWITCH
Measure the switch resistance.
NOTE:
• Make sure the battery voltage is applied to the
terminal No. 13(+) and 5(–) when measuring resis-
tance, because the main switch is controlled by mi-
crocomputer.
EI-01286
EI-01287
GW-7
GLASS/WINDOWS/MIRRORS
7 6 5 4 3 2 1
16 15 14 13 12 11 10 9 8
12V
GW-00477