Subaru B9 TRIBECA WX 2007 Manual page 835

asieps_tobira.book 5 ページ ２０１２年２月１０日 金曜日 午後３時２６分
3. Glass Lid
A: REMOVAL
1) Completely close the glass lid, and then open
the sunshade.
2) Remove the cover (A), and then remove the
®
TORX bolts (B).
CAUTION:
The thread locker is applied to the TORX
so use the new parts once they are removed.
3) Remove the glass lid carefully.
B: INSTALLATION
Install in the reverse order of removal.
C: ADJUSTMENT
Loosen the glass lid mounting TORX
and then adjust the height with moving the lid.
Glass Lid
®
bolts,
(A)
(B)
SR-00091
®
bolts (A),
SR-5
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
Difference in height between glass lid and roof
panel L:
± ±
2.0 1.0 mm (0.079 0.039 in)
(A)
D: FORCED DRIVE
If glass lid dose not operate or is not supplied with
power, move the glass lid using the hexagon
*
wrench .
*
: L shape universal purpose hexagon wrench
bolt width 4 mm (0.16 in)
1) Remove the spot map light. <Ref. to LI-30, RE-
MOVAL, Spot Map Light.>
2) Remove the sunroof opening trim.
3) Remove the sun visor clip.
4) Insert the hexagon wrench securely until it
touches the motor shaft edge.
CAUTION:
Make sure not to bend or wrinkle the roof trim
during work.
5) Turn the hexagon wrench, and move the glass
lid.
• Turning right, the glass lid open.
• Turning left, the glass lid close.
L
SR-00117
EI-00501