Subaru B9 TRIBECA WX 2007 Manual page 588

asieps_tobira.book 13 ページ ２０１２年２月１０日 金曜日 午後３時２６分
2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the {Each System Check}.
2) On the «System Selection Menu» display screen, select the {Integ. unit mode}.
3) On the «Integ. unit mode failure diag» display screen, select the {Current Data Display & Save}.
4) On the «Current Data Display & Save» display screen, select the {12 Data Display}.
5) Using the scroll key, scroll the display screen up or down until the desired data is shown.
• A support list contains both of analog and digital data, and they are shown in the following table.
3. DISPLAY OF ANALOG DATA
Items to be displayed
BATT Voltage (Control)
BATT Voltage (BACK UP)
IG Power Supply Voltage
ACC voltage
Illumination VR voltage
Illumi. output d-ratio
Ambient temp sensor V
Ambient Temperature
Fuel level voltage
Fuel level resistance
key-lock solenoid V
number of regist.
Front Wheel Speed
VDC/ABS latest f-code
Blower fan steps
Fuel level resistance2
Fuel consumption
Coolant Temp.
Vehicle lateral G
SPORT Shift Stages
Shift Position
Off delay time
Auto lock time
Subaru Select Monitor
Unit of measure Description
10 — 15 V Body integrated unit input value
10 — 15 V Body integrated unit input value
10 — 15 V Body integrated unit input value
10 — 15 V Body integrated unit input value
0 — 5 V Body integrated unit output value
0 — 100% Body integrated unit input value
0 — 5 V Body integrated unit input value
–40 — 87.5°C Body integrated unit output value
0 — 8 V Body integrated unit input value
0 — 102.3 Ω Body integrated unit input value
6 — 12 V Body integrated unit output value
0 — 4 No. of Keyless keys to register
km/h CAN data input value
DTC display
CAN data input value
(Temporarily)
0 — 2 levels CAN data input value
0 — 102.3 Ω
CAN data output value
cc/s CAN data input value
–40 — 130°C CAN data input value
2
m/s CAN data input value
0 — 7 levels CAN data input value
0 — 7 levels CAN data input value
OFF, Short,
Body integrated unit setting items
Normal, Long
20, 30, 40, 50, 60
Body integrated unit setting items
seconds
LAN(diag)-13
LAN SYSTEM (DIAGNOSTICS)
Note
Always
Always
Ignition switch ON
Ignition switch ACC
Small light switch ON
Small light ON
Illumination volume is other than bright.
Ignition switch ON
Ignition switch ON
Ignition switch ON
Ignition switch ON
Key warning switch ON, in range other
than parking Ignition ON
Reception from VDC unit
It is normal when DTC is not been input
even if this code is displayed.
Reception from VDC
0: OFF, 1: Low, 2: 2 levels or more
Reception from air conditioner ECM
Reception from body integrated unit
Reception from ECM and transmission to
center monitor
Reception from ECM
Reception from VDC unit
Manual mode operating information
(0: Light OFF; 1 — 5: Gear display; 6:
Fail; 7: ATF temperature High/Low)
Reception from TCM
0: 1; 1: 2; 2: 3; 3: 4; 4: D; 5: N; 6: R; 7: P
shift position (8 indicates no input)
On manual mode, 8 is displayed.
Reception from TCM
Customize setting
Customize setting