Subaru B9 TRIBECA WX 2007 Manual page 726

asieps_tobira.book 28 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS)
E: DTC 29 ODS FAILURE
DTC DETECTING CONDITION:
• Occupant detection sensor is faulty.
• Occupant detection control module is faulty.
• Occupant detection harness is faulty.
• Rear airbag harness is faulty.
• Fuse No. 25 (in joint box) is blown.
Step
1 CHECK POOR CONTACT OF CONNEC-
TORS.
Check for poor contact of the connectors
between the occupant detection control module
and airbag control module.
2 CHECK DIAGNOSTIC TROUBLE CODE
(DTC).
READ DIAGNOSTIC TROUBLE CODE (DTC)
FOR THE AIRBAG SYSTEM.
Check
Is there poor contact?
Is "2C Belt Tension Sensor fail-
ure or 37 Buckle Switch failure"
displayed in the diagnostics
code?
OD(diag)-28
Yes No
Reconnect the Go to step 2.
connector. If the
fault is not fixed,
replace the airbag
harness.
Perform the diag- Check the seat
nosis according to harness, and if any
each DTC. fault is found,
replace the seat
harness. If the fault
is not fixed, replace
the occupant
detection system.
<Ref. to SE-10,
PASSENGER'S
SEAT, DISASSEM-
BLY, Front Seat.>