Subaru B9 TRIBECA WX 2007 Manual page 846

asieps_tobira.book 6 ページ ２０１２年２月１０日 金曜日 午後３時２６分
WIPER AND WASHER SYSTEMS
3. Combination Switch (Wiper)
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the driver's airbag module. <Ref. to AB-
14, REMOVAL, Driver's Airbag Module.>
3) Remove the steering wheel. <Ref. to PS-14, RE-
MOVAL, Steering Wheel.>
4) Remove the screws and remove the steering
column covers (upper & lower).
5) Disconnect the connector from the combination
switch.
6) Remove the three screws, and pull out the com-
bination base switch assembly toward you.
7) Remove the screws which secure the switch,
then remove the combination switch.
Combination Switch (Wiper)
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1. COMBINATION SWITCH
1) Inspect the continuity between each connector
terminal.
SL-00258
Front
Rear
LI -00332
2) If continuity is not as specified, replace the
switch.
WW-6
9 8 7 6 5 4 3 2 1
18 17 16 15 14 13 12 11 10
Switch position Terminal No.
Less than 1 Ω
LO 7 and 17
HI 8 and 17 Less than 1 Ω
Washer ON 2 and 11 Less than 1 Ω
Washer ON 2 and 12 Less than 1 Ω
2 and 10
2 and 12
2 and 13
OFF
10 and 12
10 and 13
12 and 13
INT 2 and 13 Less than 1 Ω
ON 2 and 10
2 and 12
Washer ON 12 and 10
2 and 10
WW-00046
Standard
1 MΩ or more
Less than 1 Ω
Less than 1 Ω