Subaru B9 TRIBECA WX 2007 Manual page 26

asieps_tobira.book 3 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Procedure
19. Seat
20. Seat belt
21. Wheel alignment
CHECKS WITH THE ENGINE RUNNING
Procedure
22. Test mode connector
23. Immobilizer system
24. Starting condition
25. Exhaust system
26. Indicator and warning lights
27. Clock
28. Audio
29. Accessory power socket
30. Navigation system
31. Rear entertainment system
32. Lighting system
33. Wiper deicer
34. Illumination control
35. Window washer
36. Wiper
37. Power window operation check
38. Sunroof
39. Door mirror
DYNAMIC TEST WITH THE VEHICLE RUNNING
Procedure
40. Brake test
41. Parking brake
42. AT shift control
43. Heater & ventilation
44. Air conditioner
45. Cruise control
CHECKS AFTER DYNAMIC TEST
Procedure
46. ATF level
47. Power steering fluid level
48. Fluid leak check
49. Water leak test
50. Appearance check 2
Pre-delivery Inspection
1. Check the seat surfaces for stains or dirt.
2. Check the seat installation conditions and functionality.
3. Check that the occupant detection system for passenger's seat operates
normally.
1. Check the seat belt installation conditions and functionality.
2. Check that the seat belt warning system operates normally.
Check that the wheel alignments are properly adjusted.
Test mode connector
1. Check that the engine starts with all keys that are equipped on vehicle.
2. 60 seconds after turning ignition switch from ON to ACC or OFF, or imme-
diately after removing the key, check that the security indicator light blinking.
Start the engine and check that the engine starts smoothly.
Check that the exhaust noise is normal and no leaks are found.
Check that all the indicator and warning lights are gone out.
Check that the clock operates normally.
Check the radio, CD player and AUX for normal operation.
Check that each of the accessory power sockets operate normally.
1. Check all display functions for normal operation.
2. Check the map disc (DVD) are provided on vehicle.
3. Check that the navigation system operates normally.
4. Check that the rear view camera operates normally.
Check that the rear entertainment system operates normally.
Check that the lighting system operates normally.
Check that the wiper deicer operates normally.
Check that the illumination control operates normally.
Check that the window washer system operates normally.
Check that the wiper system operates normally.
Check the power window for normal operations.
Check that the sunroof operates normally.
Check that the remote control mirror operates normally.
Check the foot brake for normal operations.
Check the parking brake for normal operations.
Check that the AT shift patterns are correct.
Check that the heater & ventilation system operates normally.
Check that the air conditioner operates normally.
Check that the cruise control system operates normally.
Check that the ATF level is correct.
Check that the power steering fluid level is normal.
Check for fluid/oil leaks.
Spray the vehicle with water and check for water leaks.
1. Remove the protective coating (if any).
2. Check the body paints for damage and stain.
3. Check the plated parts for damage and rust.
PI-3
PRE-DELIVERY INSPECTION
Check point
Check point
Check point
Check point