Subaru B9 TRIBECA WX 2007 Manual page 175

asieps_tobira.book 100 ページ ２０１２年２月１０日 金曜日 午後３時２６分
AIRBAG SYSTEM (DIAGNOSTICS)
Step
1 CHECK POOR CONTACT OF CONNEC-
TORS.
Check for poor contact of the connectors
between the airbag control module, side airbag
module LH and the side airbag sensor LH.
2 CHECK AIRBAG REAR HARNESS LH (SIDE
AIRBAG SENSOR HARNESS LH).
1) Turn the ignition switch to OFF, disconnect
the battery ground cable, and wait more than 20
seconds.
2) Disconnect the connector (AB21) from seat
belt pretensioner (LH).
3) Disconnect the connector (AB31) from cur-
tain airbag module (LH).
4) Disconnect the connector (AB20) from
(AB19).
5) Disconnect the connector (AB17) from air-
bag control module.
6) Connect the connector (1U) in the test har-
ness U to connector (AB17).
7) Disconnect the connector (AB23) from side
airbag sensor (LH), and connect the connector
(2V) in test harness V to connector (AB23).
8) Measure the resistance between connector
(4U) in the test harness U and connector (3V) in
the test harness V.
Connector & terminal
(4U) No. 3 — (3V) No. 4:
(4U) No. 1 — (3V) No. 5:
(4U) No. 2 — (3V) No. 1:
(4U) No. 4 — (3V) No. 2:
3 CHECK AIRBAG REAR HARNESS LH (SIDE
AIRBAG SENSOR HARNESS LH).
Measure the resistance between connector
(4U) in the test harness U and chassis ground.
Connector & terminal
(4U) No. 3 — Chassis ground:
(4U) No. 1 — Chassis ground:
(4U) No. 2 — Chassis ground:
(4U) No. 4 — Chassis ground:
4 CHECK AIRBAG CONTROL MODULE.
1) Connect all the connectors.
2) Erase the memory.
3) Perform the Inspection Mode.
4) Read the DTC.
5 CHECK ANY OTHER DTC ON DISPLAY.
Diagnostic Chart with Trouble Code
Is there poor contact?
Is the resistance less than 10
Ω?
Is the resistance more than 1
MΩ?
Is the same DTC displayed?
Is any other DTC displayed?
AB(diag)-100
Check Yes
Replace the airbag
rear harness LH
along with the body
harness.
Go to step 3.
Go to step 4.
Replace the side
airbag sensor
(LH). <Ref. to AB-
20, Side Airbag
Sensor.> Replace
the airbag control
module if not oper-
ating normally
even after replac-
ing the sensor.
<Ref. to AB-19,
Airbag Control
Module.>
Check DTC using
"List of Diagnostic
Trouble Code
(DTC)". <Ref. to
AB(diag)-47, List
of Diagnostic Trou-
ble Code (DTC).>
No
Go to step 2.
Replace the airbag
rear harness LH
along with the body
harness.
Replace the airbag
rear harness LH
along with the body
harness.
Go to step 5.
Finish the diagno-
sis.