Subaru B9 TRIBECA WX 2007 Manual page 659

asieps_tobira.book 84 ページ ２０１２年２月１０日 金曜日 午後３時２６分
LAN SYSTEM (DIAGNOSTICS)
2. BODY INTEGRATED UNIT
Item
Operate the illumination volume,
Illumination VR illumination light is controlled
power supply according to the change of voltage
on data display.
Check the fuel level resistance and
Fuel level resis-
fuel level resistance 2. Both
tance
resistances are same.
When rear wiper SW to ON, data
R wiper SW input
display turns to ON.
When rear wiper switch to ON,
R wiper output
output signal turns to ON.
Keyless entry LOCK/UNLOCK the
Keyless Entry
doors.
When brake pedal is depressed,
Brake SW
it turns to ON.
The shift lock releases when
Shift lock solenoid
depressing the brake pedal.
Body integrated
Does Vehicle equipment
unit registration
correspond to setting values?
function setting
When changing customize setting,
Customize
the registration completes correctly.
Switch the shift (UP/DOWN) on
Manual mode Manual mode. Indicator is changed
in 1 — 2.
Each checking item operate
Function check
correctly. (Except for not equipped)
After locking with keyless entry
system and open the door, the
Security
security system operates and the
horn sounds.
General Diagnostic Table
Operation
YES
Illumination light is
controlled with
changing of data.
Same values
Turns to ON.
Turns to ON.
Operate
Turns to ON.
Released
Correspondence
Registered
Change
Operate
Horn sounds.
(Security system
operates.)
LAN(diag)-84
Specifications
NO
Inspect the
illumination
volume.
Compare the input and
Inspect the body
output values of body
integrated unit.
integrated unit.
Inspect the rear
wiper switch.
If not operate with output
Replace the body
turned to ON, check the
integrated unit.
rear wiper motor.
If the antenna is OK,
Inspect the
replace the body
keyless antenna.
integrated unit.
Inspect the brake
switch.
Inspect the shift
lock.
Reconfigure the
values according to
vehicle equipment.
Inspect the body Return to original state
integrated unit. after making changes.
Inspect the shift
lever.
Inspect for non- Module is normal if output
functional actuator. switches to ON.
Horn does not activate if
Inspect the
siren is set to ON by
security system.
customizing.
Note
—
—
—
—
—
—