Subaru B9 TRIBECA WX 2007 Manual page 385

asieps_tobira.book 32 ページ ２０１２年２月１０日 金曜日 午後３時２６分
EXTERIOR/INTERIOR TRIM
10.Side Garnish
A: REMOVAL
(1) Front fender garnish
(2) Front door garnish
1) Remove the clip on the bottom side of the vehi-
cle body, and the clip that is attached with the front
and rear mudguards.
2) Remove the double sided tape and the clip on
the vehicle side, and remove the side sill spoiler.
(1) Insert a thin piece of string (A) of 0.8 mm
(0.031 in) (fishing line, etc.) between the vehicle
body and the door garnish.
(2) Cut the double sided tape, and remove the
clip using a clip remover.
(A)
Side Garnish
(2)
(1)
(3) Rear door garnish
(4) Side sill garnish
EI-00153
EI-32
(5)
(3)
(5) Rear quarter garnish
(6) Garnish end cover
NOTE:
• To optimize the effect of solvent, slide the thread
along body without removing the double-sided tape
on the surface of body and spoiler.
• If it is difficult to remove the double-sided tape,
warm it up to approx. 40°C (104°F).
• If the double-sided tape remains thick on the sur-
face due to interfacial peeling, apply solvent after
slicing off the double-sided tape using a cutter.
(A) (B)
(A) Panel
(B) Door garnish
(C) Double-sided tape
(6)
(4)
EI-01256
(C)
EI-00478