Subaru B9 TRIBECA WX 2007 Manual page 598

asieps_tobira.book 23 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Subaru Select Monitor
LAN SYSTEM (DIAGNOSTICS)
5) After setting, make sure that vehicle equipment is same as the setting changed in the {Current Data Dis-
play & Save}.
CAUTION:
• It is possible to control the original functions of vehicle when settings above are corresponded to
vehicle equipment.
• Do not change the settings except for setting above during operation of equipment setting.
• Be sure not to change Factory initial setting except installation of new body integrated unit.
NOTE:
For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MAN-
UAL".
10.FUNCTION CHECK
In order to check the body integrated unit function, inspect the body integrated unit and actuator using Sub-
aru Select Monitor without operating switches.
1) On the «Main Menu» display screen, select the {Each System Check}.
2) On the «System Selection Menu» display screen, select the {Integ. unit mode}.
3) On the «Integ. Unit mode failure diag» display screen, select the {Function Check}.
4) Select the item to be operated on the «Function Check» display screen and select the [OK].
5) Selecting [OK] starts, [NO] cancels the operation and [OK] returns to the System Operation Check Mode
display screen.
NOTE:
If not equipped (based on area or condition), process will not go on.
LAN(diag)-23