Subaru B9 TRIBECA WX 2007 Manual page 506

asieps_tobira.book 27 ページ ２０１２年２月１０日 金曜日 午後３時２６分
7. Blower Motor Unit Assembly
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the glove box. <Ref. to EI-37, REMOV-
AL, Glove Box.>
3) Disconnect the connectors of the A/C control
module, intake door actuator, blower motor, power
transistor and blower resistor.
4) Lift the floor mat.
5) Loosen the bolt and nut to remove blower motor
unit assembly.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to AC-6, HEATER COOLING
UNIT, COMPONENT, General Description.>
<Ref. to AC-8, BLOWER MOTOR UNIT, COM-
PONENT, General Description.>
Blower Motor Unit Assembly
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
AC-01276
AC-27