Subaru B9 TRIBECA WX 2007 Manual page 838

asieps_tobira.book 8 ページ ２０１２年２月１０日 金曜日 午後３時２６分
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
B: INSTALLATION
CAUTION:
When installing the motor assembly, be careful
not to move the sunroof cable.
1) Align the coulisse assembly and link assembly in
the same position.
(1)
(2)
(3)
(1) Front
(2) Coulisse ASSY
(3) Link ASSY
(4) 4.7 mm (0.185 in)
2) Install the motor assembly.
3) Connect the harness connector of motor assem-
bly, and then connect the battery ground cable to
battery.
4) Perform the initialize operation of motor.
(1) Tilt up the glass lid.
(2) Release the switch once, and press the tilt
up switch again for 15 seconds.
(3) When the glass lid is raised a little and on tilt
up position, release the switch for the moment.
(4) Keep pressing the tilt up switch within 5 sec-
onds from releasing the switch, glass lid auto-
matically performs the tilts down → slides open
→ slides close operation, then the initialize op-
eration is completed.
Sunroof Motor
(4)
SR-00094
SR-8
5) Check the operation of sunroof with following ta-
ble.
Operation
(1) Glass lid closes completely.
(2) Glass lid tilt up to the top position.
(3) Glass lid lowers completely.
(4) Glass lid opens completely.
(5) Glass lid closes 150 mm (5.91 in)
away from the completely closed posi-
tion.
(6) Glass lid closes completely.
6) Install the trim in the reverse order of removal.
Switch position
Close
Tilt up
Tilt down
Open
Close
Close