Subaru B9 TRIBECA WX 2007 Manual page 518

asieps_tobira.book 39 ページ ２０１２年２月１０日 金曜日 午後３時２６分
18.Hose and Tube
A: REMOVAL
CAUTION:
• When disconnecting/connecting hoses, do
not apply an excessive force to them. After in-
stalling, check that no torsion or excessive ten-
sion applied to the hoses.
• Seal the disconnected hose with a plug or vi-
nyl tape to prevent foreign matter from enter-
ing.
1. FRONT
1) Disconnect the ground cable from the battery.
2) Using the refrigerant recovery system, dis-
charge refrigerant. <Ref. to AC-21, PROCEDURE,
Refrigerant Recovery Procedure.>
3) Remove the evaporator unit mounting bolt (A)
and low-pressure hose bracket bolt (B).
4) Remove the low-pressure hose attaching bolts
(C).
5) Disconnect the low-pressure hose from evapo-
rator unit.
6) Disconnect the low-pressure hose from com-
pressor.
7) Remove the low-pressure hose from vehicle.
8) Remove the high-pressure hose attaching bolt
(D).
9) Disconnect the high-pressure hose from com-
pressor.
10) Disconnect the high-pressure hose from con-
denser.
11) Remove the high-pressure hose from vehicle.
12) Remove the high-pressure tube attaching bolt
(E).
Hose and Tube
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
13) Remove the high-pressure tube from vehicle.
2. REAR
1) Disconnect the ground cable from the battery.
2) Using the refrigerant recovery system, dis-
charge refrigerant. <Ref. to AC-21, PROCEDURE,
Refrigerant Recovery Procedure.>
3) Remove the sheet and floor mat. <Ref. to EI-47,
REMOVAL, Floor Mat.>
4) Remove the ECM bracket. <Ref. to FU(H6DO)-
33, REMOVAL, Engine Control Module (ECM).>
5) Remove the quick connectors (A and B).
ST 73499XA01A REMOVER PS
ST 73499XA00A REMOVER PD
NOTE:
Description for handling the special tool
1. Face collar side (A) of the quick connector (1) to
the remover (2), and set lock part (B) on the stopper
side (C) of the remover.
(1)
(A)
AC-39
(A)
(B)
(D)
(C)
(D)
(E)
AC-01482
(B) (C)
(2)
AC-01494