Subaru B9 TRIBECA WX 2007 Manual page 25

asieps_tobira.book 2 ページ ２０１２年２月１０日 金曜日 午後３時２６分
PRE-DELIVERY INSPECTION
1. Pre-delivery Inspection
A: GENERAL DESCRIPTION
The purposes of the pre-delivery inspection (PDI) are as follows.
• Remove the additional parts used for ensuring the vehicle quality during transportation and restore the ve-
hicle to its normal condition.
• Check the vehicle before delivery is in normal condition.
• Check the vehicle or parts for any damage occurred during transportation or storage.
• Check the vehicle after repair is in normal condition.
• Make sure to provide a complete vehicle to customer.
For above reasons, all SUBARU dealers (dealerships) must carry out the PDIs before delivery of vehicle.
Refer to this manual unless otherwise specified.
B: PRE-DELIVERY INSPECTION (PDI) PROCEDURE
STATIC CHECKS JUST AFTER VEHICLE RECEIPT
Procedure
1. Appearance check
2. Tire check
3. Fuse installation
4. Lock/unlock and open/close operation checks
of doors.
5. Operation check of child safety lock system
6. Check the rear gate for lock/unlock and open/
close operations.
7. Operation check of fuel lid opener lock release
lever
8. Accessory check
9. Operation check of front hood lock release sys-
tem
10. Battery
11. Brake fluid
12. Engine oil
13. AT front differential oil
14. Engine coolant
15. Window washer fluid
16. Front hood latch check
17. Keyless entry system
18. Alarm system
Pre-delivery Inspection
1. If the vehicle is covered with protective coating, visually check the vehicle
body for damage and dents. If the protective coating has been removed,
visually check the body painted area for damage or stains in detail.
2. Visually check the glass and light lenses for any damage, cracks or exces-
sive gaps between body sheet metal.
3. Visually check the plated parts for any damage.
1. Check the tires for damage, defective, and dents on wheels.
2. Check the tire air pressure.
If the vehicle is about to be delivered to customer, attach a back-up fuse.
1. Using the key, check the trunk lid can be locked or unlocked normally.
2. Open and close all doors to check that there are no defective.
3. Operate the power door lock switch to check that the door (rear gate) is
locked and unlocked normally.
Check the child safety lock system operates normally.
1. Check if the rear gate can be unlocked normally through the emergency
hole.
2. Open and close the rear gate to see that there are no abnormal condi-
tions.
Operate the fuel lid opener to check that the fuel lid is unlocked normally.
Check that the following accessories are provided.
• Owner's manual
• Warranty booklet
• Maintenance note
• Spare key
• Jack
• Tool set
• Spare tire
Operate the front hood lock release lever to check that the front hood is
unlocked normally.
Check the battery terminals for any abnormal conditions such as rust and
trace of battery fluid leaks.
Check that the fluid level is normal.
Check that the oil level is normal.
Check that the AT front differential oil level is normal.
Check that the engine coolant level is normal.
Check that the window washer fluid level is normal.
Check that the hood is closed and latched securely.
Check that the keyless entry system operates normally.
Check that the alarm system operates normally.
PI-2
Check point