Subaru B9 TRIBECA WX 2007 Manual page 56

asieps_tobira.book 5 ページ ２０１２年２月１０日 金曜日 午後３時２６分
• If damage, open circuit or rust is found on airbag
system wiring harness, do not use a soldering
equipment to repair. Replace the faulty harness
with a new genuine part.
N N N N N N G G G G N N G G NG G N N N N N N N N N N NG
• Install the wiring harness securely with the spec-
ified clips to avoid interference or tangled with other
parts.
• When painting or performing sheet metal work
on the front part of the vehicle, including the front
wheel apron, front fender and front side frame, re-
move the front sub sensors and wiring harness of
airbag system.
• When painting or performing sheet metal work
on the side of the vehicle, including the side sill,
center pillar and front and rear doors, remove the
side airbag sensors and wiring harness of the air-
bag system.
N N N N G G NG NG G G G G G G NG G N N N N N N N N N G G G G G G G G G N N G N NG N N N
• Do not use the airbag or pretensioner parts from
other vehicles. Always replace the defective parts
with new parts.
• Never reuse a deployed airbag module and pre-
tensioner.
• Do not discard the uninflated airbag or preten-
sioner.
General Description
G G G G G G G G G G G G G G G G G G G G
AB-01539
AB-00125
G G G G G
AB-01542
AB-5
• When airbag control module, front sub sensor,
side airbag sensor and curtain airbag sensor are
removed, do not reuse the bolts and nuts of them.
Always use new bolts and nuts for them.
• Do not drop each airbag module, airbag control
module and each sensor, or store these parts un-
der high temperature over 93°C (199°F), or let wa-
ter, oil or grease get on them; the internal parts may
be damaged or the reliability may be greatly low-
ered.
N N N N N G NG N N N NG G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G
• After removal of each parts for airbag system,
keep them with the pad facing upward on a dry,
clean and flat surface without heat, light sources,
moisture and dust.
AIRBAG SYSTEM
AB-01538
AB-00056