Subaru B9 TRIBECA WX 2007 Manual page 749

asieps_tobira.book 7 ページ ２０１２年２月１０日 金曜日 午後３時２６分
2. Front Seat
A: REMOVAL
CAUTION:
The airbag system is fitted with a backup power
source. After disconnecting the battery ground
cable, the airbag may deploy if you do not wait
for 20 seconds before starting the service of
airbag system.
NOTE:
When removing the front seat of memory-equipped
power seats, always perform the initialize operation
on the memory function after installing the seat to
the vehicle. <Ref. to SE-34, ADJUSTMENT, Power
Seat System.>
Failure to do so may cause the abnormal operation
of the memory function.
1. DRIVER'S SEAT
1) Remove the headrest.
2) Tilt the backrest forward, and move the seat for-
ward.
3) Remove the rear leg cover, and remove the two
bolts at the rear side of slide rail.
4) Move the seat backward, remove the front leg
cover, and then remove the 2 bolts at the front side
of the slide rail.
5) Disconnect the ground cable from battery, and
wait for more than 20 seconds before starting work.
6) Disconnect the connector under the seat.
• Seat belt buckle switch connector
• Seat position sensor connector
• Side airbag connector
• Seat heater connector
• Power seat connector
7) Remove the seat from vehicle.
2. PASSENGER'S SEAT
CAUTION:
Refer to "CAUTION" of "General Description"
before starting the work. <Ref. to SE-6, CAU-
TION, General Description.>
1) Remove the headrest.
2) Tilt the backrest forward, and move the seat for-
ward.
3) Remove the rear leg cover, and remove the bolt
at the rear side of the slide rail.
4) Move the seat backward, remove the front leg
cover, and then remove the bolt at the front side of
the slide rail.
5) Disconnect the ground cable from battery, and
wait for more than 20 seconds before starting work.
Front Seat
6) Disconnect all the connectors of connector hold-
er in the backside of seat cushion.
• Harness connector of occupant detection control
module
• Side airbag connector
• Power seat connector
• Seat heater connector
7) Remove the seat from vehicle.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Tighten the slide rail installing bolt gradually in sev-
eral steps to the specified torque in the order as
shown in the figure.
(1)
(3)
CAUTION:
After installing the driver's seat, use the Subaru
Select Monitor to confirm that the seat position
sensor LH is operating properly. <Ref. to AB(di-
ag)-33, DISPLAY OF STATUS INFORMATION,
OPERATION, Subaru Select Monitor.>
NOTE:
When removing the front seat of memory-equipped
power seats, always perform the initialize operation
on the memory function after installing the seat to
the vehicle. <Ref. to SE-34, ADJUSTMENT, Power
Seat System.>
Failure to do so may cause the abnormal operation
of the memory function.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-2, COMPONENT, General
Description.>
SE-7
SEATS
(4)
(2)
SE-00479