Subaru B9 TRIBECA WX 2007 Manual page 805

asieps_tobira.book 29 ページ ２０１２年２月１０日 金曜日 午後３時２６分
4. CHECK DOOR SWITCH
Step
1 CHECK INPUT FROM EACH DOOR SWITCH
1) Connect the Subaru Select Monitor to data
link connector.
2) Turn the ignition switch to ON.
3) Select {Integ. unit} from main menu.
4) Select the {Current Data Display & Save}.
5) Check the door switch input to the body inte-
grated unit when opening the each door (front
RH and LH, rear RH and LH).
2 CHECK THE DOOR SWITCH CIRCUIT
1) Turn the ignition switch to OFF.
2) Disconnect the harness connector of body
integrated unit (i84).
3) Disconnect the defective door switch har-
ness connector (any of R9, R12, R16, R22).
4) Measure the resistance between harness
connector terminals.
Connector & terminal
(i84) No. 19 — (R12) No. 1: (front door LH)
(i84) No. 32 — (R9) No. 1: (front door RH)
(i84) No. 31 — (R22) No. 1: (rear door LH)
(i84) No. 18 — (R16) No. 1: (rear door RH)
3 CHECK THE GROUND CIRCUIT OF DOOR
SWITCH
1) Disconnect the defective door switch har-
ness connector (any of R9, R12, R16, R22).
2) Measure the resistance of harness connec-
tor and chassis ground.
Connector & terminal
(R9) No. 3 — Chassis ground:
(front door LH)
(R12) No. 3 — Chassis ground:
(front door RH)
(R22) No. 3 — Chassis ground:
(rear door LH)
(R16) No. 3 — Chassis ground:
(rear door RH)
4 CHECK DOOR SWITCH.
1) Disconnect the defective door switch har-
ness connector (any of R9, R12, R16, R22).
2) Measure the resistance between door
switch terminals.
Terminals
No. 1 — No. 3:
5 CHECK DOOR SWITCH.
Measure the resistance between door switch
terminals.
Terminals
No. 1 — No. 3:
Security System
Check
Is the input signal detected
when opening the each door
(front RH and LH, rear RH and
LH)?
Is the resistance less than 10 Ω? Go to step 3.
Is the resistance less than 10 Ω? Go to step 4.
Is the resistance more than 1
MΩ when door switch is
pushed?
Is the resistance less than 1 Ω
when door switch is released?
SL-29
SECURITY AND LOCKS
Yes No
The door switch When the input sig-
circuit is OK. nal cannot be
detected in some
door switch, Go to
step 2.
Repair the har-
ness.
Repair the har-
ness.
Go to step 5. Replace the door
switch.
Check the body Replace the door
integrated unit. switch.
<Ref. to
LAN(diag)-2, Basic
Diagnostic Proce-
dure.>