Subaru B9 TRIBECA WX 2007 Manual page 739

asieps_tobira.book 11 ページ ２０１２年２月１０日 金曜日 午後３時２６分
B: INSTALLATION
1. OUTER SEAT BELT ASSEMBLY
Install in the reverse order of removal.
CAUTION:
• The parts of driver and passenger sides are
not the same. Before installation, make sure
that the correct part is used.
• Be careful not to twist the seat belts during
installation.
Tightening torque:
<Ref. to SB-2, FRONT SEAT BELT, COMPO-
NENT, General Description.>
2. INNER SEAT BELT ASSEMBLY
Install in the reverse order of removal.
CAUTION:
• After the driver's and passenger's inner seat
belt assembly installation, check that the seat
belt buckle switch operates normally using the
Subaru Select Monitor in {Status Data} of "Air-
bag System". <Ref. to AB(diag)-33, DISPLAY
OF STATUS INFORMATION, OPERATION, Sub-
aru Select Monitor.>Improper buckle switch op-
eration may cause airbag system malfunction.
• Inner seat belt assembly harness (1) must be
routed securely as shown in the figure, as it can
affect the performance of the seat position sen-
sor and occupant detection system.
• Driver's seat
Front Seat Belt
Tightening torque:
C: INSPECTION
1. OUTER SEAT BELT ASSEMBLY
Check for the following, and replace with new parts
if necessary.
• Pretensioner is cracked or deformed.
• The belt tension sensor is cracked. Or deformed.
• Seat belt is slackened, bent or worn. Seat belt is
abnormally wound or extended.
2. INNER SEAT BELT ASSEMBLY
Check for the following, and replace with new parts
if necessary.
(1)
• Inner seat belt assembly is deformed or dam-
aged.
• Seat belt buckle cannot be engaged properly.
SB-00317
SB-11
• Passenger's seat
(1)
<Ref. to SB-2, FRONT SEAT BELT, COMPO-
NENT, General Description.>
SEAT BELT SYSTEM
SB-00318