Subaru B9 TRIBECA WX 2007 Manual page 755

asieps_tobira.book 13 ページ ２０１２年２月１０日 金曜日 午後３時２６分
3. Second-Row Seats
A: REMOVAL
1. LH&CTR SEAT
1) Tilt the backrest forward, and move the seat for-
ward.
2) Remove the slide rail cover at the seat rear side,
and remove the two bolts.
3) Move the seat to the rear end.
4) Remove the slide rail cover at the seat front side,
and remove the two bolts.
5) Remove the seat from vehicle.
2. RH SEAT
1) Tilt the backrest forward, and move the seat for-
ward.
2) Remove the slide rail cover at the seat rear side,
and remove the two bolts.
3) Move the seat to the rear end.
4) Remove the slide rail cover at the seat front side,
and remove the two bolts.
5) Remove the seat from vehicle.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-2, COMPONENT, General
Description.>
NOTE:
Tighten the slide rail bolts diagonally in two or three
steps by gradually increasing the torque, until they
reach the specified torque.
Second-Row Seats
C: DISASSEMBLY
1. LH SEAT
1) Remove the seat from vehicle. <Ref. to SE-13,
LH&CTR SEAT, REMOVAL, Second-Row Seats.>
2) Remove the headrest.
3) Remove the hinge outer cover.
4) Remove the two reclining hinge bolts of 2nd seat
CTR, then remove the seat backrest.
SE-00596
5) Remove the two reclining hinge bolts of 2nd seat
LH on each of the left and right sides, then remove
the seat backrest.
SE-00597
6) Remove the backrest back cover.
SE-13
SEATS
SE-00598
SE-00599
SE-00600
SE-00601