Subaru B9 TRIBECA WX 2007 Manual page 674

asieps_tobira.book 12 ページ ２０１２年２月１０日 金曜日 午後３時２６分
LIGHTING SYSTEM
10.Headlight Assembly
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the air intake duct.
3) Remove the engine front cover.
4) Disengage the three clips, and then turn over the
mud guard.
5) Remove the three bolts securing the headlight
assembly from the lower side of vehicle.
6) Remove the two bolts and then remove the
headlight assembly.
Headlight Assembly
7) Disconnect the connector and then detach the
rear headlight assembly.
B: INSTALLATION
Install in the reverse order of removal.
C: ADJUSTMENT
1. HEADLIGHT AIMING
NOTE:
Aiming of this headlight can be adjusted only in the
vertical direction. It cannot be adjusted in the hori-
zontal direction.
CAUTION:
Turn off the light before adjusting the headlight
beam level. If it is necessary to inspect the
IN-02134
beam level, do not turn on the light for more
than two minutes.
NOTE:
Before checking the headlight beam level, be sure
of the following:
• Check the area around the headlight for any
scratches, damage or other type of deformation.
• Make sure that the vehicle is parked on a level
surface.
• Make sure that the inflation pressure of tires are
correct.
CO-02176
• Check that the vehicle fuel tank is full.
1) Bounce the vehicle several times to normalize
the suspension.
2) Make certain that someone is seated in the driv-
er's seat.
3) Measure the heights of headlights and the dis-
tance between the centers of left and right LO
beam bulbs.
4) Turn the headlights on and then adjust the low
beam pattern.
NOTE:
Adjust the headlight beam level by turning the ad-
justing screw. The adjusting screw can be access-
ed from two directions described in the figure.
LI-00503
LI-00504
LI-12
LI-00505