Subaru B9 TRIBECA WX 2007 Manual page 818

asieps_tobira.book 42 ページ ２０１２年２月１０日 金曜日 午後３時２６分
SECURITY AND LOCKS
14.Rear Gate Latch Assembly
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the rear gate trim. <Ref. to EI-51, RE-
MOVAL, Rear Gate Trim.>
3) Disconnect the harness connector of rear gate
latch assembly.
4) Remove the two screws.
5) Remove the rear gate latch assembly.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the lock works correctly after installa-
tion.
C: INSPECTION
1) Disconnect the rear gate lock actuator harness
connector.
2) Connect the battery to rear gate lock actuator
terminals.
2 1
4 3
Terminal No.
No. 1 (+) and No. 2 (–)
Replace the rear gate latch assembly if faulty.
Rear Gate Latch Assembly
SL-00447
SL-00449
Actuator operation
Lock → Unlock
SL-42