Subaru B9 TRIBECA WX 2007 Manual page 435

asieps_tobira.book 28 ページ ２０１２年２月１０日 金曜日 午後３時２６分
GLASS/WINDOWS/MIRRORS
18.Rear Quarter Glass
A: REMOVAL
Remove the glass in the same procedure as for
windshield glass. <Ref. to GW-18, REMOVAL,
Windshield Glass.>
A
(1)
A
C
C
(3)
B B
B
(1) Locating pin
(2) Dam rubber
(3) Fastener
(4) Adhesive
(5) Encap molding
Rear Quarter Glass
B: INSTALLATION
1) Install the dam rubber.
2) Cut out the nozzle head and apply adhesive to
the glass end surface as shown.
(2)
(1)
(4)
(2)
(5)
GW-00500
3) Install the glass in the same procedure as for
windshield glass. <Ref. to GW-19, INSTALLA-
TION, Windshield Glass.>
4) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
• When door is opened/closed after glass is bond-
ed, always lower the door glass first, and then
open/close it carefully.
• Move the vehicle slowly.
• For minimum drying time and vehicle standing time
before driving after bonding, follow instructions or in-
struction manual from the adhesive manufacturer.
5) After curing of adhesive, pour the water on exter-
nal surface of vehicle to check that there are no wa-
ter leaks.
NOTE:
When a vehicle is returned to the user, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
GW-28
(2)
A-A
60
(9)
(2)
(3)
(3)
C-C B-B
(1) Dam rubber
(2) Adhesive
(3) Encap molding
(4) 8 mm (0.31 in)
(5) 9 mm (0.35 in)
(6) 2 mm (0.07 in)
(7) 4 mm (0.15 in)
(8) 11 mm (0.43 in)
(9) 10 mm (0.39 in)
(3)
(1)
(4)
(5)
(6)
(2)
GW-00501