Subaru B9 TRIBECA WX 2007 Manual page 275

asieps_tobira.book 8 ページ ２０１２年２月１０日 金曜日 午後３時２６分
CRUISE CONTROL SYSTEM (DIAGNOSTICS)
8) When the set speed is canceled by itself (without
any cancel operations) or when the cruise control
cannot be set after the set operation, DTC will be
displayed on the screen after selecting the {Check
Cancel Code} on the engine malfunction diagnosis
screen.
NOTE:
There are the {Latest Code} and the {Memory
Code} in DTC. The latest code recognized during
current test drive is displayed in the {Latest Code},
while the codes in past test drive are displayed in
the {Memory Code}. DTCs by the diagnosis of
faulty switches relating to the system and cruise
control are also displayed in the {Memory Code}.
9) Perform Engine DTC Clear Memory operation.
<Ref. to EN(H6DO)(diag)-49, OPERATION, Clear
Memory Mode.>
DTCs of switches relating to the system and cruise
control are deleted by clearing memory on the en-
gine side.
NOTE:
DTC will be cleared by turning ignition switch to
OFF.
Subaru Select Monitor
3. REAL-TIME DIAGNOSIS
1) Connect the Subaru Select Monitor.
2) Turn the ignition switch and cruise control main
switch to ON.
3) Run the Subaru Select Monitor.
4) On the «Main Menu», select the {2. Each Sys-
tem Check}.
5) On the «System Selection» display screen, se-
lect the {Engine Control System}.
6) Select the [OK] after the information of engine
type is displayed.
7) On the «Cruise Control Diagnosis» display
screen, select the {Current Data Display/Save}.
8) Make sure that normal display is shown when
operated as follows:
• Depress and release the brake pedal. (Stop light
switch and brake switch turn ON.)
• Turn the main switch to ON.
• Turn the «CANCEL» switch to ON.
• Turn the «SET/COAST» switch to ON.
• Turn the «RESUME/ACCEL» switch to ON.
• Depress or release the clutch pedal.
• Place the shift lever in any position other than
neutral.
NOTE:
• For details concerning operation procedure, re-
fer to the "SUBARU SELECT MONITOR OPERA-
TION MANUAL".
• Refer to "List of Diagnostic Trouble Code (DTC)"
for DTC. <Ref. to CC(diag)-12, List of Diagnostic
Trouble Code (DTC).>
CC(diag)-8