asieps_tobira.book 20 ページ 2012年2月10日 金曜日 午後3時26分
Side Airbag Sensor
AIRBAG SYSTEM
9. Side Airbag Sensor
A: REMOVAL
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the center pillar lower trim. <Ref. to EI-
44, CENTER PILLAR LOWER TRIM, REMOVAL,
Side Trim.>
4) Remove the seat belt retractor of the front outer
seat belt. <Ref. to SB-10, OUTER SEAT BELT AS-
SEMBLY, REMOVAL, Front Seat Belt.>
5) Remove the nut and disconnect the airbag con-
nector to remove side airbag sensor.
AB-00634
B: INSTALLATION
CAUTION:
• Do not reuse the bolt and nut.
• Always use new bolts and nuts for them.
Install in the reverse order of removal.
Tightening torque:
8 N·m (0.82 kgf-m, 5.9 ft-lb)
C: INSPECTION
Check for the following, and replace the damaged
parts with new parts.
• Mounting bracket or connector of side airbag
sensor is damaged.
• Side airbag is deployed.
AB-20