Subaru B9 TRIBECA WX 2007 Manual page 594

asieps_tobira.book 19 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Item
Center display setting
Wiper deicer
Rear fog light setting
Factory initial setting
Security setting
6. REGISTRATION BODY INTEGRATED
UNIT (EQUIPMENT SETTING)
CAUTION:
Body integrated unit is core of LAN system, and
also can select the function of all vehicle sys-
tem control. It is possible to control the original
functions of vehicle when registrations of body
integrated unit and function setting are corre-
sponded to vehicle equipment.
If registrations and function setting are differ-
ent from vehicle equipment, vehicle system
does not operate normally and diagnosis can-
not be performed correctly. Pay attention to fol-
lowing item.
• Be sure to correspond registrations and
function settings to vehicle equipment.
• Do not change the settings of vehicle improp-
erly.
• Confirm key illumination does not blink or
"Factory initial setting" of body integrated unit
registrations is "Market". If "Factory initial set-
ting" is set to "Factory," key illumination blinks
with ignition key turned to ON to give warning
of unconfirmed settings.
• Key illumination does not blink with ignition
switch turned to ON and go off with door
closed.
• Be sure to register immobilizer if body inte-
grated unit is replaced with a new part. (Model
with immobilizer)
• Make a registration of immobilizer when the
parts related to immobilizer have been re-
placed. Refer to the "REGISTRATION MANUAL
FOR IMMOBILIZER".
• Do not install or register an immobilizer relat-
ed module of other registered vehicles in order
to diagnose failures or inspect functions.
Subaru Select Monitor
Item to confirm
Yes No
Yes No
Yes No
Factory Market
Yes No
1) Turn the ignition switch to OFF.
2) Connect the Subaru Select Monitor to data link
connector.
3) Turn the ignition switch to ON and run the Suba-
ru Select Monitor.
4) On the «Main Menu» display screen, select the
{Each System Check}.
5) On the «Each System Check» display screen,
select the {Integ. Unit mode} and then select the
«ECM customizing».
6) Change the setting with UP/DOWN key and se-
lect the [OK].
Also, it is possible to set by changing to factory
mode and pressing the wiper deicer switch, rear
defogger switch, rear fog light switch and door lock
switch.
NOTE:
Center display yes/no can be set only by the select
monitor.
• List of body integrated unit registration item
NOTE:
Setting is different depending on grade of vehicle
and what is equipped.
LAN(diag)-19
LAN SYSTEM (DIAGNOSTICS)
Remarks
Yes: Vehicle equipped with MFD and navigation display
No: Vehicle not equipped with MFD nor navigation
display
Yes: Vehicle equipped with wiper deicer
No: Vehicle not equipped with wiper deicer
Not supported in North American specifications (Set to No)
Do not change to the factory mode. Set to market when
using normally.
Not supported by North American specifications
LAN00189