Subaru B9 TRIBECA WX 2007 Manual page 349

asieps_tobira.book 20 ページ ２０１２年２月１０日 金曜日 午後３時２６分
EXTERIOR BODY PANELS
B: INSTALLATION
1) Put a wooden block on jack and place the rear
door on that.
2) Apply grease to the moving part of door hinges.
3) Install the rear door to upper hinge and lower
hinge adjusting by jack.
4) Tighten bolt of door checker.
5) Connect the door harness connector.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to EB-10, REAR DOOR PANEL, COM-
PONENT, General Description.>
Rear Door
C: ADJUSTMENT
1) Open the rear door, loosen the door-side bolts of
upper and lower hinges to align the position for ver-
tical and horizontal direction of rear door panel.
EB-00013
2) Loosen the screw (A) and tap striker (B) using
plastic hammer to adjust the gap between rear end
surface of rear door panel and body surface.
CAUTION:
Do not use an impact wrench. Welding area on
the striker nut plate is easily broken.
EB-20
EB-00015
(A)
(B)
EB-00017