Subaru B9 TRIBECA WX 2007 Manual page 752

asieps_tobira.book 10 ページ ２０１２年２月１０日 金曜日 午後３時２６分
SEATS
18) Remove the bolt (A) and hook (B) on left and
right side, and then remove the seat cushion frame
from seat rail assembly.
(B)
19) Remove the hooks (A), and then remove the
seat cushion from seat cushion frame.
(A)
20) Remove the hog rings (A), and then remove the
seat cushion cover from seat cushion pad.
: (A)
21) Remove the hooks and hog rings at the bottom
of headrest, and then remove the headrest cover
from headrest.
Front Seat
(A)
SE-00416
(A)
SE-00391
SE-00591
SE-00342
SE-10
2. PASSENGER'S SEAT
CAUTION:
• If the seat cushion cover is removed or re-
placed, make sure to perform passenger detec-
tion system adjustment after installing the seat
to the vehicle. <Ref. to OD(diag)-17, SYSTEM
CALIBRATION (REZEROING),
Subaru Select Monitor.>
Failure to do so may cause improper activation
of passenger's airbag.
• The passenger detection system (passenger
seat only) control unit, passenger detection
sensor, seat cushion pad and seat cushion
frame are considered as a single seat cushion
pad and frame assembly. Never remove the
passenger detection control unit or the pres-
sure sensor from the seat cushion frame.
• If the seat cushion cover is removed, make
sure to replace the wire on the seat cushion
side with a new wire.
1) Remove the seat from vehicle. <Ref. to SE-7,
PASSENGER'S SEAT, REMOVAL, Front Seat.>
2) Refer to the disassembly procedures for the driv-
er's seat.
NOTE:
The back side of the seat cushion is affixed by a
hook (A) and hog ring (B).
(A)
(A)
: (B)
OPERATION,
SE-00642